- Window/Türsensor für Funk Alarm System SP310
- The sensor monitors the opening and closing of your windows
- Sensor is monitored by base
- Different zone types adjustable
- Sabotage protection
- Rolling code
- 2-way communication
- Frequency: 868MHz
- Batteries: 2x button cell CR2032 (included)
- Dimensions: Sensor: approx. 7x3x1.5cm Magnet: approx. 3.5x1.1x1.4cm
- Scope of delivery: 1x window/door sensor, batteries, adhesive pads
incl. 19% VAT
Description
The window/door sensor for the basis of the SP310 alarm series from Safe2Home.
The sensor/contact monitors the opening and closing of your windows or doors and thus protects you from burglars etc.
If the magnetic contact is interrupted, the sensor immediately sends an alarm signal to the base and an alarm/intrusion alarm is triggered. In the event of an alarm, an SMS/call/wifi notification is immediately sent to your smartphone.
The sensor can be attached to the window or door with the enclosed adhesive pad. You can also screw the sensor in place if required. (is not necessary in most cases)
Make sure that the arrow markings on the sensor and magnet point towards each other.
The difference in height and width must not exceed 1.5 cm. (up to this value, the contacts are still considered closed)
Different zone types can be set
You can set different zone types for this sensor in the basic menu or via the app
The most important zone types for everyday use:
Burglary:
Alarm is triggered directly in the „armed state“.
Derasure:
Alarm is activated in the „armed state“ after the set
Delay time triggered. (recommended)
Fire / Gas:
Alarm is always triggered (in armed and disarmed state).
Deact. :
No alarm is triggered. (sensor is deactivated)
Sharp / Blurred:
When a sensor is triggered, the system is armed/disarmed. For example, for a lock cylinder.
Bell:
The sensor emits a "ding-dong" sound when sensors are triggered.
No alarm is triggered. You will still receive a push message.
Rolling code
Each contact/sensor has a rolling code. This means that as soon as a radio signal (e.g. window opening) is emitted, the sensor generates a new code so that it cannot be intercepted and used by unauthorized persons.
Example: In the past, it was possible to intercept the radio signal of the remote control from a car and thus open the vehicle; this is not possible with the SP310.
2-way communication:
The SP310 base has 2-way communication.
This means that the sensors and base communicate with each other (via radio). A query of the radio signal and the battery status of the sensor is carried out automatically every 5 minutes. If, for example, a sensor does not send a signal (e.g. because it is switched off due to an empty battery), the base unit immediately checks for the missing signal and sends a message via the app and displays this on the base unit.
In addition, you can manually query the radio signal and battery status via the app, or set the query frequency of 5 minutes as required.
